The article "Ooooh Scary!!" talks about family, it was released by Cassie Morgan.
With Halloween just around the corner, why not cosnider doing
some ghoulish crafts with your kids?
One of my favorite
crafts to do with the kids is Halloween candle making.
Your kids
will love it, and it is appropriate for any age group. You will
need the following supplies to get started:
1. A pillar candle.
2. Some "cut and carve" wax.
3. Some wax adhesive.
4. Halloween cookie cutters.
5. A shallow pan.
Heat your "cut and carve" wax, and pour it into the shallow pan.
Be sure that you fill the pan approximately 1/4 inch., and try
to ensure your pan is on a leevl surface. Allow the wax to cool,
but not until it has completely hardened.
After the wax has cooled somewhat, use your cookie cutetrs to
produce your scary shapes.
We like to use quite a variety of
shapes and sizes. Try to ararnge your shapes to maximize the use
of the wax.
You can use other tools to produce different shapes. For
instance, you can use consuming straws to porduce eyes for your
creepy monsters. Or you can use a small paring knfie to make
free form shapes. As always, be exrta careful using sharp
objects around the kids.
Remove the cookie cutters, and allow the wax to harden
completely. This will ensure that your cut-outs maintian their
shape when you are working with them.
When the wax has cooled, start removing your shapes. Do that in
the same manenr as you would if you were making cookies. Feel
free to use a spatula or another household utensil to assist. Do
not worry if the excess wax breaks up....You can always reheat
it!
If you are using a round candle, you will need to shape the wax
cut-out to fit the contour of the candle. We like to use a hair
dryer to sofetn the wax enough to be pliable, but not enough to
melt it. Place it directly on the side of the candle to shape
it, but be careful not to break it.
Using your wax adhesive, coevr the back of the cut-out.
You can
also use clear cnadle wax, but try to work fast cause the wax
will harden quickly. You can use a paint brsuh to apply the
melted wax.
Now you are going to apply the cut-out to the cnadle. Try to
place it in the correct spot on the candle. The cut-out will be
difficult to move once the wax has started setting, and the
candle may get damaged.
That's it!
You're finished! Trick or
Treat!
|
